wisconsinwhe.blogg.se - Firmware bolt aquila max

Stepper Drivers – 4x Trinamic TMC2209 in UART Mode – 2A RMS, 2.8A Peak Output, Sensorless homing capableįilament Sensor Port – Works with our EZOut sensor and OEM Creality/Sovol sensors Official Firmware – TH3D Unified 2 (Marlin 2.0)

If you’re eco-conscious these are worth checking out!ĬPU – STM32F405RGT6 – 168mhz, 32-Bit, 1MB Flash, 192K RAM

Recycled Filaments Recycled filaments are made from recycled materials.

These are more expensive than PLA or ABS but their strength is unmatched. These filaments are typically able to be printed without an enclosure and need a high nozzle temp of 230-250C and bed temp up to 80C.

Nylon Filaments Nylon is a very STRONG filament where durability and layer adhesion is needed.

ABS should be printed inside an enclosure to ensure part strength and reduce warping.

ABS Filaments ABS is a very strong plastic with high-temperature resistance (100C+).

PETG filaments have excellent layer adhesion and handle heat up to 70-80C for higher ambient temperatures.

PETG Filaments PETG is an alternative to ABS for those who do not have an enclosure to print in.

PLA Filaments PLA is a biodegradable, renewable plastic that is easy to print and affordable.